| Config PPP
|
Config PPP Setup
- First, open Config PPP by clicking on the Apple icon and then going to the control panel and clicking on Config PPP.
- At the bottom of the Config PPP screen, click New.
- On the screen that comes up, there will be a series of blanks for you to type in. In the first blank (ppp server name), type Hyperusa. Towards the bottom of the screen, there will be a box that says phone number. Type the local access number in that blank. In the blank that says modem init, type AT&F1.
- Next, click the button that says authentication. On this screen, type your username in the Auth ID blank and type your password in the password blank. Then click OK.
- It will take you back to the previous screen. On this screen, click Done.
- Now your Config PPP should be ready to dial-out and connect to the Internet.
|
|
Config PPP